Scissor Lift License Calgary - The operation of scissor lifts carries an inherent chance of danger. Any type of powered machinery needs right handling in order to avoid accidents causing damage or injury. Companies must ensure that workers using this particular machinery have the required qualifications.
Unqualified employees should not be allowed by their companies to utilize scissor lifts. The lift is made to raise materials and people to varied heights. Failure to know and fully abide by safety standard could result in damage to the lift or injuries for users.
For those who use scissor lifts, there is no legislation governing the use of fall protection. Then again, manufacturers could recommend the utilization of fall protection and in some cases tying off in scissor lifts might be required by employer rules, local regulations or job-specific risk assessment.
Before utilizing the machinery, the scissor-lift operator should carry out a thorough inspection to ensure the machine is in good working order. This is the operator's task, even if the unit has already been in service that same day. The machine's operator's guidebook contains a pre-operation checklist.
Examples of what to look for when performing a pre-operation inspection comprise checking tire-inflation pressure, and checking controls in the platform and ground controls to make sure they are working. When extending or retracting the boom, look for delayed movement on the fly section that could indicate loose cables. While operating the controls, make certain that the emergency stop switches are working. Operate functions against the machine's cutout switches. Test the boom control system by cycling a boom lift to the furthest extent of its operating envelope. Safety limiters should automatically stop the unit before it moves into an unstable position, if they are working correctly. If they aren't, shut down the lift and ensure that it is repaired before utilizing it for a second time.
Safe operating measures must be followed always, with the levers being operated with controlled, even pressure. A control lever should never be pushed from one position to the opposite position. The lever must be shifted to neutral, before stopping, and after that proceeding in the desired direction. When released, levers and control switches should return to the neutral position automatically. Depress the foot switch prior to operating platform controls.